No matter how many tile rails you fit into a bathroom, there never seems to be enough!

The treatment works in a kitchen or other rooms as well as in a bathroom.





You will need:
Tape measure
Screwdriver
Template (cut one from scrap paper if one didn't come with the rail)
Masking tape
Pencil
Level
Drill and ceramic tile drill bits (2mm and recommended size for rail anchors)



Here's how:
1. Measure and mark the height of the bar.

2. Using a level, position the template and tack to the wall with masking tape. Mark the position on the tile with pencil to show drilling position.

3. You need to drill holes for the rail anchors. Using the smaller bit, apply firm pressure to avoid the bit slipping and damaging the tile. This hole only needs to be as deep as the tile. Change bits and use the larger bit to continue into the wall for the anchors.

4. Remove the paper template.

5. Screw the mounting brackets into the or wall anchor, insert the bar into the posts, and place the posts in position over the brackets. Tighten the set screws underneath the posts.